Smooth-Cast 300 is a casting compound consisting of two liquid prepolymers that can be mixed and cured to form a durable plastic.
Smooth-Cast 300 is easy to mix and pour, and it offers the convenience of a one-to-one mix ratio. It readily accepts fillers and can be pigmented. Smooth-Cast 300 is superior for cold cast metal applications. Fully cured castings are tough, durable, machinable, and paintable. They resist moisture and mild solvents.
Smooth-Cast 300 consists of two liquid components, Part A (Yellow Label) and Part B (Blue Label). When combined in a mixing ratio of one to one by volume, Smooth-Cast quickly cures to a solid and durable plastic. Hardness is Shore 70D.
Applications for Smooth-Cast 300 include small to medium size sculptures, prototype models, cold cast bronze, special effect props, decorative jewelry, etc. Package of two 16 oz (.47 L) jars.
Castings can be displayed outdoors after priming and painting. Unpainted castings will yellow over time — more quickly when exposed to ultra-violet light.
Caution — Keep out of reach of children. Smooth-On Liquid Rubber and Liquid Plastics products should be used only under adult supervision. Use with adequate ventilation. The Smooth-Cast 300 prepolymers can cause severe irritation to skin and eyes, and vapors can cause lung damage. Uncured silicone rubber compound can be irritating to the eyes and skin. Remove from skin with soap and water. Flush eyes for 15 minutes and seek medical attention.
Caution — If sanding or machining cured Smooth-Cast 300, wear a dust mask or respirator to prevent inhalation of residual particles.
Note — The shelf life of Smooth-On liquid rubber and liquid plastic compounds is drastically reduced after opening. Remaining product should be used as soon as possible. Replace the lids on both containers immediately after dispensing to prolong the shelf life of the unused product.
™ Smooth-On is a trademark. ® Smooth-Cast 300 is a registered trademark
This exceptionally hard white liquid plastic casting compound is for creating casts with very fine detail.
It creates an ultra-low viscosity casting resin that yields virtually bubble-free castings in 7-10 minutes, depending on mass and mold configuration.